UNTERMINATED MAD PRO-SERIES DRIVESHAFT SENSOR FOR FERROUS TOOTH TARGET

UNTERMINATED MAD PRO-SERIES DRIVESHAFT SENSOR FOR FERROUS TOOTH TARGET

$104.40
Skip to product information
UNTERMINATED MAD PRO-SERIES DRIVESHAFT SENSOR FOR FERROUS TOOTH TARGET

UNTERMINATED MAD PRO-SERIES DRIVESHAFT SENSOR FOR FERROUS TOOTH TARGET

$104.40

View store information

UNTERMINATED MAD PRO-SERIES DRIVESHAFT SENSOR FOR FERROUS TOOTH TARGET

Sensor gap should be 0.020-0.040" Measure with feeler gauge or screw in until sensor touches reluctor ring then back out 1/2 to 1 full turn.

The sensor has an LED in the end so you can test if it's reading your target just by watching the light flash. These are perfect for any normal ferrous toothed wheel, ABS ring or even the bolt heads under a rotor hat. Will also fit the Strange Ultra housing.

Internal wiring: +12v power/BROWN, signal/BLACK, ground/BLUE

HOLLEY USERS-

It can receive 12v power from any source you like. For the signal J1A12 or A3 are preferred.

Suggest using a22 ground, b20 power, shield drain j2-b14

10-30 volt power

5/16" X 24 thread pitch (fine)

Cable is 16" long

Our PRO-SERIES Driveshaft Reluctor Ring is here-

https://madracingparts.com/products/mad-pro-series-driveshaft-reluctor-ring

You may also like